I checked in the port.c of their example and the defines do not exist but they are in the example from you webįreeRTOSv9.0.0FreeRTOSSourceportableMikroCARM_CM4Fport.c port.cĠ 1004 interrupt handler (xPortSysTickHandler at 0x000F) port.cħ25 317 Operator ” is not applicable to these operands ” port.cħ83 324 Undeclared identifier ‘portFIRSTUSER INTERRUPTNUMBER’ in expression port.cħ87 324 Undeclared identifier ‘portNVIC IPREGISTERS OFFSET16′ in expression port.cĨ28 324 Undeclared identifier ‘portAIRCR_REG’ in expression port.c

Since putting it back in there are different errors as it now configASSERT_DEFINED = 1 :-Ġ 1004 interrupt handler (vPortSVCHandler at 0x000B) port.cĢ96 324 Undeclared identifier ‘portNVIC IPREGISTERS OFFSET16′ in expression port.cĢ96 324 Undeclared identifier ‘portFIRST USERINTERRUPT NUMBER’ in expression port.cĠ 1004 interrupt handler (xPortPendSVHandler at 0x000E) port.cĤ79 348 Assembler instruction ‘BL’ was not found. Hi ,the freeRTOS.h file supplied with their demo had the whole definition of the configASSERT commented out. Void vPortValidateInterruptPriority( void )Ĭonfig_ASSERT is defined in freeRTOS.h, is this a possible bug or do I need to change interrupt priorities ? to an invalid interrupt priority being missed. ulCurrentInterrupt, so ulCurrentInterrupt getting corrupted cannot lead interrupted by a higher priority interrupt. However that should not matter as an interrupt can only itself be global – which makes vPortValidateInterruptPriority() non re-entrant. Limitations in the MikroC inline asm means ulCurrentInterrupt has to be I have searched and this snippet of port.c file (please ignore the quote before the hash) :.

I get the following error after compile :-Ġ 360 Unresolved extern ‘vPortValidateInterruptPriority’ queue.c XQueueSend(displayQueueHandle, &msgBuffer, 0xFFFFFFFFU) // Post Byte to Display task UART1_Write(rxmsgBuffer.msgData) // Used for testing interrupt

MsgBuffer.msgData = UART1_Read() // read the received data If (xSemaphoreTake(xBinarySemaphore, portMAX_DELAY) = pdPASS) and sends reads byte and send to display task PortYIELD_FROM_ISR( xHigherPriorityTaskWoken ) XSemaphoreGiveFromISR( xBinarySemaphore, &xHigherPriorityTaskWoken ) Void UART Rx() iv IVTINT USART1 ics ICSAUTOīaseType_t xHigherPriorityTaskWoken = pdFALSE Hi, my first few days with freeRTOS I have been using the MikroC latest release ARM compiler and all was well, until I created tasks to handle UART interrupt.

Mikroc uart interrupt example